Nye nettsider

Vi jobber fremdeles med forbedringer på våre nye nettsider. For å kjøpe standarder eller legge til i abonnement må du logge på gamle nettsider (siden du er på nå) med gammelt brukernavn og passord.

 

ISO 15875-2:2003

Standard
NOK 1 245,00 (eks. mva) InformationOvervåk standarden
basket Skriv ut på papir basket Trykket og innbundet
Få nettbasert tilgang
Status: Check Gyldig
Norsk tittel: Plastics piping systems for hot and cold water installations — Crosslinked polyethylene (PE-X) — Part 2: Pipes
Engelsk tittel: Plastics piping systems for hot and cold water installations — Crosslinked polyethylene (PE-X) — Part 2: Pipes
Varetype: Standard
Språk: Engelsk
Utgave: 1 (2003-12-08)
Antall sider: 12
Pris:

NOK 1 245,00 (eks. mva)
NOK 1 556,25 (ink. mva)

Omfang: <p>This Part of <std><std-ref>EN ISO 15875</std-ref></std> specifies the characteristics of pipes made from crosslinked polyethylene (PE-X) for piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water, whether or not intended for human consumption (domestic systems), and for heating systems, under design pressures and temperatures appropriate to the class of application (see <std>Table 1 of <std-ref>EN ISO 15875-1:2003</std-ref></std>).</p><p>This standard covers a range of service conditions, (application classes), design pressures and pipe dimension classes. For values of <italic>T</italic><sub>D</sub>, <italic>T</italic><sub>max</sub> and <italic>T</italic><sub>mal</sub> in excess of those in <xref ref-type="table" rid="tab_1">Table 1</xref> of Part 1, this standard does not apply.</p><non-normative-note><label>NOTE 1</label><p>It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.</p></non-normative-note><p>It also specifies the test parameters for the test methods referred to in this standard.</p><p>In conjunction with the other Parts of <std><std-ref>EN ISO 15875</std-ref></std> (see Foreword) it is applicable to PE-X pipes, their joints and to joints with components of PE-X, other plastics and non-plastics materials intended to be used for hot and cold water installations.</p><p>It is applicable to pipes with or without (a) barrier layer(s).</p><non-normative-note><label>NOTE 2</label><p>In the case of plastics pipes provided with a thin barrier layer, e.g. to prevent or greatly diminish the diffusion of gases and the transmission of light into or through the pipe wall, the design stress requirements are totally met by the base polymer (PE-X).</p></non-normative-note>
Fastsatt: 2003-12-08
ICS: 83.140.30 - Plastrør, - deler og -ventiler
23.040.20 - Plastrør
91.140.60 - Vannforsyningssystemer