Nye nettsider

Vi jobber fremdeles med forbedringer på våre nye nettsider. For å kjøpe standarder eller legge til i abonnement må du logge på gamle nettsider (siden du er på nå) med gammelt brukernavn og passord.

 

ISO 15875-3:2003

Standard
NOK 1 245,00 (eks. mva) InformationOvervåk standarden
basket Skriv ut på papir basket Trykket og innbundet
Få nettbasert tilgang
Status: Check Gyldig
Norsk tittel: Plastics piping systems for hot and cold water installations — Crosslinked polyethylene (PE-X) — Part 3: Fittings
Engelsk tittel: Plastics piping systems for hot and cold water installations — Crosslinked polyethylene (PE-X) — Part 3: Fittings
Varetype: Standard
Språk: Engelsk
Utgave: 1 (2003-12-08)
Antall sider: 11
Pris:

NOK 1 245,00 (eks. mva)
NOK 1 556,25 (ink. mva)

Omfang: <p>This Part of <std><std-ref>EN ISO 15875</std-ref></std> specifies the characteristics of fittings for crosslinked polyethylene (PE-X) piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water, whether or not intended for human consumption, (domestic systems) and for heating systems, under design pressures and temperatures appropriate to the class of application (see <std>Table 1 of <std-ref>EN ISO 15875-1:2003</std-ref></std>).</p><p>This standard covers a range of service conditions (application classes) and design pressure classes. For values of <italic>T</italic><sub>D</sub>, <italic>T</italic><sub>max</sub> and <italic>T</italic><sub>mal</sub> in excess of those in <xref ref-type="table" rid="tab_1">Table 1</xref> of Part 1, this standard does not apply.</p><non-normative-note><label>NOTE</label><p>It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.</p></non-normative-note><p>It also specifies the test parameters for the test methods referred to in this standard.</p><p>In conjunction with the other Parts of <std><std-ref>EN ISO 15875:2003</std-ref></std> (see Foreword) it is applicable to fittings made from crosslinked polyethylene (PE-X) and to fittings made from other materials which are intended to be fitted to pipes conforming to <std><std-ref>EN ISO 15875-2:2003</std-ref></std> for hot and cold water installations and whereby the joints conform to the requirements of <std><std-ref>EN ISO 15875-5</std-ref></std>.</p><p>This standard is applicable to fittings of the following types:</p><list list-type="bullet"><list-item><label>—</label><p>mechanical fittings;</p></list-item><list-item><label>—</label><p>electrofusion fittings;</p></list-item><list-item><label>—</label><p>fittings with incorporated inserts.</p></list-item></list>
Fastsatt: 2003-12-08
ICS: 23.040.45 - Rørdeler av plast
83.140.30 - Plastrør, - deler og -ventiler
91.140.60 - Vannforsyningssystemer